FLOVENT Technical Papers

Modeling Smoke and Fire in a hotel bedroom

Heinrich Manz, Swiss Federal Laboratories for Materials Testing and Research, Section Applied Physics in Building, Duebendorf, Switzerland
Weiran Xu, Flomerics Inc., Southborough, MA, USA
Mark Seymour, Flomerics Ltd, Hampton Court, Surrey, UK

Proc. 8th Int. Conf. on Air Distribution in Rooms, Roomvent 2002, Copenhagen, Denmark, 8-11 Sept. 2002, 65-68

Experimental-Numerical Comparison for a High-Density Data Center: Hot Spot Heat Fluxes in Excess of 500 W/ft²

Saurabh K. Shrivastava, American Power Conversion Corporation
Madhusudan Iyengar, IBM Systems & Technology Group
Bahgat G. Sammakia, Dept. of Mechanical Engineering
Roger Schmidt, IBM Systems & Technology Group 2455
James W. VanGilder, American Power Conversion Corporation

IEEE ITHERM Conference, 30 May - 2 June 2006, San Diego, USA

Airflow Uniformity Through Perforated Tiles in a Raised-Floor Data Center

James W. VanGilder, American Power Conversion Corporation
Roger R. Schmidt, IBM Corporation

Simulation of hot air stack effect in a high-rise condominium

Mr. Chee-Onn Chan, Dr. Teng-Kiat Lim, O.Y.L R&D Centre

Locating the Optimum Position to Place an Indoor Air conditioner in Studio Type Apartment to Achieve Good Thermal Comfort

Teng Kiat Lim, O.Y.L R&D Centre
Yah Li Ong, M. Hamdi, Department of Engineering Design and Manufacture, Faculty of Engineering, University of Malaya

Possibility to Use Solar Induced Ventilation Strategies in Tropical Conditions by Computational Fluid Dynamic Simulation

Agung Murti Nugroho, Mohd Hamdan bin Ahmad, Makmal Sain Bangunan
Department of Architecture Faculty Built Environment, UNIVERSITI TEKNOLOGI MALAYSIA

Determining the Optimum Position of Air-Conditioning System in a
Typical Studio Type Apartment Layout to Achieve Good Thermal
Comfort

Y.L. Ong, T.K. Lim , M.Hamdi, Department of Engineering Design and Manufacture, Faculty of Engineering, University of Malaya

An experimental and numerical study of turbulent flow inside studio apartments

Teng Kiat Lim, O.Y.L. R&D Centre, Selangor, Malaysia.
Yah Li Ong, M. Hamdi, Department of Engineering Design and Manufacture, Faculty of Engineering, University of Malaya

CFD and Experimental Study of the Temperature Distribution in a Present Rubber Smoking Room

M. Promtong, P. Kirirat, J. Taweekun, P. Tekasakul, Department of Mechanical Engineering, Faculty of Engineering, Prince of Songkla University

Computation of thermal environment near outdoor condensing units in a high-rise residential building

T. K. Lim, Department of Research & Application, O.Y.L. Research and Development Centre

A Passive Courtyard Home in Jaipur, India:
Design Analysis for Thermal Comfort in a Hot Desert Climate

Thulasi Narayan, Arizona State University

ISES (International Solar Energy Society) conference, Orlando, Florida, USA, June 2005.

Contribution of the multi-dimensional calculation codes in evaluating air flows and transfer of pollutants to a ventilated room

L. Ricciardi, D. Guerra, Institute of Radiation Protection and Nuclear Safety Laboratory for Studies and Modelling in Aerial Dispersion and Confinement

Congrès Contaminexpert 2005

Modelling of flow separation over a backward-facing step using Flovent

Philip Davies and Yongmann Chung
School of Engineering, University of Warwick

Thermal Trends and Inflections Influencing the IT Roadmap

David S. De Lorenzo, Intel Labs

Thermal Considerations in Cooling Large Scale High Compute Density Data Centers

Chandrakant D. Patel, Ratnesh Sharma, Cullen E. Bash and Abdlmonem Beitelmal, Hewlett-Packard Laboratories

Dimensionless Parameters for Evaluation of Thermal Design and Performance of Large-Scale Data Centers

Ratnesh K. Sharma, Cullen E. Bash, Chandrakant D. Patel, Hewlett-Packard Laboratories

Raised Floor Computer Data Center: Effect on Rack Inlet Temperatures of Chilled Air Exiting both the Hot and Cold Aisles

Roger Schmidt, Ethan Cruz, IBM Corporation

Fire Modeling - FLOVENT Validation Report

D Stribling (Flomerics)

Airflow Modelling in Cleanroom Design

M. J. Seymour (Flomerics)

An innovative approach to the environmental system design for TLC rooms in Telecom Italia

Paola Cinato, Claudio Bianco, Luigi Licciardi(CSELT - Torino - Italy)
Fabio Pizzuti, Mauro Antonetti, Maurizio Grossoni (Telecom Italia - Roma)

Natural Ventilation and Sustainability Designing with Computational Fluid Dynamics

F. Iannone (Dipartmento di Architettura e Urbanistica - Politecnico di Bari)

Simulation Techniques for Designing Passive Cooling of Historical Buildings

F. Iannone (Dipartmento di Architettura e Urbanistica - Politecnico di Bari)

The State of the Art in CFD for Ventilation Design

D Stribling (Flomerics)

Optimisation of Airflow with CFD Techniques

H. Nyman (Cleanroom Technology AB)

A Real Application of Airflow Modeling in Optimizing Cleanroom Design

G. Pollock (M+W Pearce Limited), D Stribling (Flomerics)

Computational Fluid Dynamics (CFD) Applied to Cleanroom and Isolator Applications

D Stribling (Flomerics)

Maintaining a Model Climate at M&S

R.G. Palmer (Oscar Faber), D Stribling (Flomerics)

Application of Lagrangian particle transport model to tuberculosis (TB) bacteria UV dosing in a ventilated isolation room

A. Alani , M.J. Seymour (Flomerics)
I.E. Barton , L.C. Wrobel (Department of Mechanical Engineering, Brunel University)

Computational Fluid Dynamics Modeling of High Compute Density Data Centers to Assure System Inlet Air Specifications

Chandrakant D. Patel, Cullen E. Bash, Christian Belady (Hewlett-Packard)
Lennart Stahl and Danny Sullivan (Emerson Energy Systems)

Numerical Modeling Of Closely Spaced Supply Diffusers In A High Air Change Rate Application

T. Abbas, W. B. Booth (BSRIA)
M. J. Seymour, P. M. Rose (Flomerics)

Contaminants Transport Modeling

A. Alani , M.J. Seymour (Flomerics)
I.E. Barton , L.C. Wrobel (Department of Mechanical Engineering, Brunel University)

A fresh approach to cooling network equipment

Peter Kiff, BT Networks and Systems

A CFD investigation into Temperature Stratification in Large Buildings

P M Rose, The Building Services Research and Information Association
M J Seymour, Flomerics LTD

Practical airflow design and optimization in clean rooms using mathematical modeling

M J Seymour, Flomerics LTD

Air movement simulation of natural ventilation in a new administration building with two open atria

Catherine Ho, Building Simulation LTD

Applications of CFD in the built environment

F Alamdari, The Building Services Research and Information Association

Moisture Movement: A study using tracer gas techniques and CFD modeling

M Kolokotroni, J Littler, Polytechnic of Central London

Computational Fluid Dynamics – a timely concept?

K G MacLeod, AMEC Design & Management, P R Waskett, Loughborough University

Flovent CFD as an aid to the measurement of air movement characteristics within buildings

M W Simons, C E Brouns, J R Waters, Coventry University

Overview of the use of Flovent in the Swiss energy saving research

D Aiulfi, Sorane SA

Ventilation Performance Assessment, Stanstead Airport Terminal – A case study

M J Seymour, Flomerics LTD, K M Bennett, The Building Services Research and Information Association, P M Rose, The Building Services Research and Information Association

The use of CFD techniques for the assessment and improvement of a workshop ventilation system

S T Awolesi, Envirotrak LTD, H B Awbi, University of Reading, M J Seymour, The Building Services Research and Information Association, R A Hiley, AEA Technology

The application of CFD in a hospital burns unit

Graham Nicholson, Thermal Biology Research Unit, Aerobiology Section, King’s College London

Climate simulation and validation for an aviary system for laying hens

E N J van Ouwerkerk, J P Voskamp, Y Aliskan
Institute of Agricultural and Environmental Engineering

Benefits of New Refrigerated Cabinet Design by Measurement of Air Temperatures and Velocities On-Site

Garry Palmer, Oscar Faber Applied Research

Oscar Faber Internal Document

Physical Validation of Flovent

Garry Palmer, Oscar Faber Applied Research

Oscar Faber Internal Document

An extract from "Controlling Indoor Climate – Passive cooling of residential buildings in hot-humid climates in China"

Z Wang, Department of Building Science, Lund University, Sweden, 1996

Use of computer modeling techniques to investigate aspects involved in cold air distribution systems

P M Rose, Air Distribution Section, The Building Services Research and Information Association, M J Seymour, Flomerics LTD

Flovent validation examples

M J Seymour, Flomerics LTD, 1991

BSRIA Internal Document

Microclimate performance of an open atrium office building: a case study in thermo-fluid modeling

F Alamdari, Thermo-Fluid Energy Ltd, Bath, S C Edwards, Hoare Lea and Partners, University of Bath, S P Hammond, School of Architecture and Building Energy, University of Bath